|
|
本帖最后由 yixuan 于 2024-10-25 22:12 编辑
Loading Environment from SPIFlash... OK
frame buffer addr: 0x900000000dc00000
In: serial,gpiobtn,usbkbd
Out: serial,vidconsole
Err: serial,vidconsole
Net: eth0: ethernet@0x16020000
************************** Notice **************************
Press c to enter u-boot console, m to enter boot menu
************************************************************
Bus ehci@0x16080000: USB EHCI 1.00
Bus ohci@0x16088000: USB OHCI 1.0
scanning bus ehci@0x16080000 for devices... 2 USB Device(s) found
scanning bus ohci@0x16088000 for devices... 1 USB Device(s) found
Autoboot in 3 seconds
unable to select a mode : -1
mmc_init: -524, time 27
** Bad device specification mmc 0 **
Couldn't find partition mmc 0
Can't set block device
Wrong Image Type for bootm command
ERROR -91: can't get kernel image!
Bootcmd="setenv bootargs ${bootargs} mtdparts=${mtdparts}; ext4load mmc 0 ${loadaddr} /boot/uImage;bootm"
Boot Kernel failed. Kernel not found or bad.
Autoboot in 3 seconds
SOC#setenv bootargs root=/dev/sda1 rootdelay=5
SOC#ext4load usb 0:1 ${loadaddr} boot/uImage
Can't set block device
SOC#usb storage
Device 0: Vendor: Mass Rev: 1.00 Prod: Storage Device
Type: Removable Hard Disk
Capacity: 14980.0 MB = 14.6 GB (30679040 x 512)
SOC#usb part 0
Partition Map for USB device 0 -- Partition Type: DOS
Part Start Sector Num Sectors UUID Type
1 1 30679039 5b2fad14-01 ee
|
|
发表于 2024-10-25 22:01:20